density of air in kg/m3
Then from CFM I can get mass flow rate (m dot) from CFM by multiplying it with the density of air, right? I need for the density of the exhaust gases from a Diesel fueled gas turbine. We'll assume you're ok with this, but you can opt-out if you wish. mrem p to Sv α conversion table, mrem p to Sv α unit converter or convert between all units of radiation absorbed dose measurement. Specific weight and density of air at standard atmospheric pressure - Imperial Units: Specific weight and density of air at standard atmospheric pressure - SI Units: © Copyright 2000 - 2020, by Engineers Edge, LLC www.engineersedge.com All rights reserved The density of gases have been listed below in alphabetical order in the units of both metric and imperial. The density of the gas in ratio with the density of air (1 kg/m3) gives the specific gravity of the gas in a ratio number. Use temperature and pressure to define the density, air density is 1.293 kg/m3 at 273 K and 1 ATM. At sea level and at 15 Â°C, air has a density of approximately 1.225 kg/m3 (0.001225 g/cm3, 0.0023769 slug/ft3, 0.0765 lbm/ft3) according to ISA (International Standard Atmosphere). DFM DFA Training Engineering Calculators if I have the ACH value of the room, then I can get the CFM from it right? document.write('